User`s manual

P4TSP-D2 BIOS Setup
22
Video Off In Suspend
This determines the manner in which the monitor is blanked.
The Choices: Yes (default), No.
Suspend Type
Select the Suspend Type.
The Choices: Stop Grant (default, P wrOn Suspend).
MODEM Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices:3 (default)/ 4 / 5 / 7 / 9 / 10 / 11 / NA.
Suspend Mode
When enabled and after the set time of system inactivity, all devices except the CPU will be
shut off.
The Choices: Disabled (defau lt), 1Min, 2Min, 4Min, 8Min, 12Min, 20M in,
30Min, 40Min, 1Hour.
HDD Power Down
When enabled and after the set time of system inactivity , the hard disk drive will be
powered down while all other devices remain active.
The Choices: Disabled (default), 1Min, 2Min, 3Min, 4Min, 5Min, 6Min, 7Min,
8Min, 9Min, 10Min, 11Min, 12Min, 13Min, 14Min, 15Min.
.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has “hung.”
The Choices: Delay 4 Sec, Instant-Off (default).
Intruder# Detection
This item allows you to enabled or disable intruder# detection
The Choices: Disabled (default), Enabled.
Wake-Up by PCI card
When you select Enable, a PME signal from PCI card returns the system to Full
On state.
The Choices: Enabled, Disabled (default).
Power On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an