User`s manual

P4TSP-D2 BIOS Setup
19
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port. Full-duplex
mode permits simultaneous two-direction transmission. Half-duplex mode
permits transmission in one direction only at a time.
The Choices: Half (default), Full.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O Address.
The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
SPP(default) Using Parallel port as Standard Printer Port.
EPP Usin g P aralle l Port as Enhanced P arallel P ort.
ECP Using P aralle l port as Extended Capabilities Port.
ECP+EPP Usin g P aralle l port as ECP & EPP mode.
ECP Mode Use DM A
Select a DMA Channel for the port.
The Choices: 3 (default), 1.
Po wer After Po we r Fail
T his setting specif ies whether your system will reboot after a power fail or
interrupts occurs.
off Leaves the computer in the power off state.
on Reboots the computer.
Former-Sts Restores the system to the status before power failure or
interrupt occurs.
The Choices: off (default), on, Former-Sts.
Game Port Address
Game P ort I/O Address.
The Choices: 201 (default), 209, Disabled.
Midi Port Address
Midi Port Base I/O Address.
The Choices: 330 (default), 300, Disabled.
Midi Port IRQ
T his determines the IRQ in which the Midi Port can use.
The Choices: 10 (default), 5.