Manualshelf

User`s manual

ManualsBrandsBiostar ManualsComputer equipmentP4TSP-D2
51525354555657585960
P4TSP-D2 BIOS Setup
16
5 Integrated Peripherals
Figure 5. Integrated Peripherals
Onboa rd IDE Device
Press Enter to configure the onboard IDE Controllers.
IDE HDD Block Mode
Block mode is also called block transfer, multip le commands, or multip le sector
read / write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block mode
(most new drives do), select Enabled for automatic detection of the optimal
number of block read / write per sector where the drive can support.
The Choices: Enabled (default), Disabled.
IDE DMA transfer access
The Choices: Enabled (default), Disabled.
On-Chip Primary/ Secondary PCI IDE
This item allows you to enable or disable the primary/ secondary IDE Channel.
The Choices: Enabled (Default), Disabled.
Primary / Secondary /Master / Slave PIO
The IDE PIO (Programmed Input / Output) fields let you set a PIO mode (0-4) for
each of the IDE devices that the onboard IDE interface supports. Modes 0 to 4
will increased performance progressively. In Auto mode, the system