User`s manual

8
Jumpers, Headers, Connectors & Slots
Floppy Disk Connector: FDD1
The motherboard provides a standard f loppy disk connector that supports 360K,
720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector supports the
prov ided f loppy drive ribbon cables.
Hard Disk Connectors: IDE1/ IDE2
The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO
Mode 0~4, Bus Master, and Ultra DMA 33/ 66/ 100 f unctionality. It has two HDD
connectors IDE1 (primary) and IDE2 (secondary).
The IDE connectors can connect a master and a slave driv e, so you can connect
up to f our hard disk driv es. The f irst hard drive should alway s be connected to
IDE1.
Peripheral Component Interconnect Slots: PCI 1-5
This motherboard is equipped with 5 standard PCI slots. PCI stands f or Peripheral
Component Interconnect, and it is a bus standard for expansion cards. This PCI
slot is designated as 32 bits.
Accelerated Graphics Port Slot: AGP1
Your monitor will attach directly to that v ideo card. This motherboard supports
video cards for PCI slots, but it is also equipped with an Accelerated Graphics Port
(AGP). An AGP card will take advantage of AGP technology f or improved video
efficiency and performance, especially with 3D graphics.
Communication Network Riser Slot: CNR1 (not support version
7.x)
The CNR specification is an open Industry Standard Architecture, and it defines a
hardware scalable riser card interf ace, which supports modem only.
Serial ATA Connector: SATA1/ SATA2
The motherboard has a PCI to SATA Controller with 2 channels SATA interface, it
s at isf ies t he SATA 1. 0 s pec and with transf er rat e of 1. 5Gb/s .
Pin Assignment Pin Assignment
1
Ground
2
TX+
3
TX-
4
Ground
5
RX-
6
RX+
1
23
4
56
7
SATA1/ SATA2
7
Ground