User`s manual

P4M900-M4
29
Video Off Method
This option determines the manner when the monitor goes blank.
V/H SYNC+Blank
(default)
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS
Initial display power management signaling.
Modem Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices: 3 (default), 4, 5, 7, 9, 10, 11, NA.
Soft-Off by PWRBTN
This item determines the behavior of system power button. Instant off turn off
the power immediately, and Delay 4 Sec. will require you to press and hold the
power button for 4 seconds to c ut off the sys tem power.
The Choices: Delay 4 Sec, Instant-Off (default).
Run VGABIOS if S3 Resume
Choos ing Enabled will make BIOS run VGA BIOS to initialize the VGA card
when system wakes up from S3 state. The system resume time is shortened if
you disable the function, but system will need AGP driver to initialize the card.
So, if the AGP driver of the VGA card does not support the init ialization feature,
the display may work abnormally o r not function after S 3.
The Choices: Auto (default), Yes, No.
Ac Loss Auto Restart
This setting specifies how your system should behave after a power fail or
interrupts occ urs. By choosing o ff will leave the co mputer in the power off state.
Choosing On will reboot the computer. Former-Sts will restore the system to the
status before power failure or interrupt occ urs.
The Choices: Off (default), On, Former-Sts.