User`s manual

NF61V Micro AM2 SE/NF61S Micro AM2 SE
1
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk yo u for choo sing our pro duct. Be fore yo u sta rt installing the
mo the rboa rd, plea se make su re you fo llow the ins tructions be low:
 Prepare a dry and stable working environment with
s uf ficie nt ligh ting .
 Always disconnect the computer from power outlet
be fo re ope ra tion.
 Befo re you take the m o the rboa rd ou t f rom a n ti -s ta ti c
bag, ground yourself properly by touching any safely
grounde d ap pliance, or use g ro unded wrist s trap to
remove the static charge.
 Avo id tou ch ing the compone nts o n mo the rboa rd o r the
rear side of the board unless necessary. Hold the bo a rd
on the edge , do not try to bend or flex the boa rd.
 Do no t lea ve any unfas tene d sma ll pa rts inside the
case after installation. Loose parts will cause short
circuits which ma y damage the equipment.
 Keep the computer from dangerous area, such as heat
so urce , humid a ir and wa te r.
1.2 PACKAGE CHECKLIST
FDD Cable X 1
HDD Cable X 1
Use r’s Ma nual X 1
Fully Setup Driver CD X 1
Rear I/O Panel for ATX Case X 1
Se ria l ATA Cab le X 1 (op tiona l)
USB 2.0 Cable X1 (optional)
S/PDIF Cable X 1 (optional)
Se ria l ATA Po we r Switch Cab le X 1 (op tiona l)
Printe r Port Cable X 1 (optiona l)