User`s manual

NF520-A2
1
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk you for choosing our pro duct. Before yo u sta rt installing the
mo the rboa rd , plea se make sure you fo llo w the ins tru ctions be lo w:
 Prepare a dry and stable working environment with
s ufficie nt ligh ting .
 Always disconnect the computer from power outlet
befo re ope ra tion .
 Befo re you take the mo the rboa rd ou t f rom a n ti-s ta ti c
bag, ground yourself properly by touching any safely
grounde d appliance, or use grounded wrist strap to
remove the static charge.
 Avo id tou ch ing the compone nts o n mo the rboa rd o r the
rear side of the boa rd unless necessary. Hold the board
on the edge, do not try to be nd or flex the board.
 Do no t leave any unfastene d small parts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
 Keep the computer from dangerous area, such as heat
source , humid a ir and wa te r.
1.2 PACKAGE CHECKLIST
HDD Cable X 1
Se ria l ATA Cab le X 1
Rear I/O Panel for ATX Case X 1
Use r’s Ma nua l X 1
Fully Setup Driver CD X 1
FDD Cable X 1 (optional)
USB 2.0 Cable X1 (optional)
S/P DIF ou t Ca ble X 1 (op tiona l)
Note: The package contents may differ by area or your motherboard version.