User`s manual

GF7100P-M7S
3
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk you for choosing our product. Before yo u start installing the
mo the rboa rd, plea se make sure you fo llo w the instructio ns be lo w:
 Prepare a dry and stable working environment with
s ufficie nt ligh ting .
 Always disconnect the computer from power outlet
be fo re ope ra tion .
 Befo re you take the mo the rboa rd ou t f rom a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounde d appliance, or use grounded wrist strap to
remove the static charge.
 Avo id tou ch ing the compone nts o n m o the rboa rd o r the
rear side of the board unless necessary. Hold the boa rd
on the edge , do not try to bend or flex the board.
 Do not leave any unfastene d small pa rts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
 Keep the computer from dangerous area, such as heat
source, humid air and wate r.
1.2 PACKAGE CHECKLIST
HDD Cable X 1
Se ria l ATA Cab le X 1
Rear I/O Panel for ATX Case X 1
Use r’s Manual X 1
Fully Setup Driver CD X 1
FDD Cable X 1 (optional)
Se ria l ATA Po we r Cab le X 1 (o ptio nal)
USB 2.0 Cable X1 (optional)
S/P DI F ou t Ca ble X 1 (op tiona l)
Note: The package contents may differ by area or your motherboard version.