Troubleshooting guide

P:\WINWORD\P:\WINWORD\Torch Service Guide 46 and 52inch screens\
Service Guide for EN069K series 46 & 52 inch LCD screen.doc Page 20
Wall Mounting
Two wall mounting brackets are provided, one each for portrait (“vertical”) and for
landscape (“horizontal”) mounting.
In the rear of the screen are three holes, each 30 mm (1
3
/
16
th
inch) square, of which two
are used for each of the two orientations.
UPS Access Computer Access
Remove 4 screws to release Remove inner six screws, or all twelve to release
(See page12) (See page 17)
For landscape mounting refer to the landscape holes and guide slots in the picture
above and use the bracket illustrated on the next page. Screw the bracket firmly to the
wall with the screws pointing upwards. Ensure that the bracket is level. It is the
responsibility of the installer to ensure that the screws used and the wall to which
the screen is attached are capable of holding the screen safely. The screen
weighs about 50kg – the fixings should be rated at least three times that value,
i.e. the wall and the screws should be able to withstand 150 kg load.
(See next page for portrait mounting)
Landscape fixing holes Portrait fixing holes
Landscape guide slots
Portrait guide slot