Owner's Manual

945P-A7B/945PL-A7B
1
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk you for choosing our pro duct. Before yo u start installing the
mo the rboa rd, plea se make su re you fo llow the ins tructions be low:
 Prepare a dry and stable working environment with
s ufficie nt lighting.
 Always disconnect the computer from power outlet
be fo re ope ration.
 Befo re you take the mo the rboa rd ou t from a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounded appliance, or use gro unded wrist strap to
remove the static charge.
 Avo id tou ch ing the compone nts o n mo the rboa rd o r the
rear side of the board unless ne cessa ry. Hold the board
on the edge, do not try to be nd or flex the board.
 Do not lea ve any unfastene d sma ll pa rts inside the
case after installation. Loose parts will cause short
circuits which ma y damage the equipment.
 Keep the computer from dangerous area, such as heat
source, humid a ir and wate r.
1.2 PACKAGE CHECKLIST
z FDD Cable X 1
z HDD Cable X 1
z Use r’s Ma nual X 1
z Se ria l ATA Cab le X 1
z Fully Setup Driver CD X 1
z Rear I/O Panel for ATX Case X 1
z USB 2.0 Cable X1 (optional)
z S/PDIF Cable X 1 (optional)
z Se ria l ATA Po we r Switch Cab le X 1 (op tiona l)