Owner's Manual

945P-A7G/945PL-A7G

S UPE R IO DE VICE

If you highlight the literal “Press Enter” next to the “Super IO Device” labe l and then press

the enter key, it will take you a submenu with the following options:

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the

system board and you wish to use it. If install and FDC or the system has no floppy

drive, select Disab led in this f ield.

The Ch o ice s : En a b le d (default), Disabled.

Onboard Serial Port 1

Select an address and corresponding interrupt for the first and second serial ports.

The Ch o ice s : Disabled, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.

Onboard Parallel Port

This item allows you to determine access onboard parallel port controller with which

I/O Address.

The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

Parallel Port Mode

The default value is SPP.

The Ch o ice s :

SPP (default) Using Paralle l port as Standard Printer Port.

EPP Using P aralle l P ort as Enhanced Parallel P ort.

ECP +EPP Using Paralle l port as ECP & EPP mode.

ECP Using Parallel port as Extended Capabilities Port.