Owner's Manual

945P-A7G/945PL-A7G
1
CHAPTER 1: INTRODUCTION
1.1 B
EFORE YOU START
Tha nk you for choosing our pro duct. Before yo u sta rt installing the
mo the rboa rd , plea se make sure you fo llow the instructions be low:
 Prepare a dry and stable working environment with
s ufficie nt ligh ting .
 Always disconnect the computer from power outlet
be fo re ope ra tion.
 Befo re you take the mo the rboa rd ou t f rom a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounde d appliance, o r use grounded wrist strap to
remove the static charge.
 Avo id tou ch ing the compone nts o n mo the rboa rd o r the
rear side of the board unless necessary. Hold the board
on the edge, do not try to bend or flex the board.
 Do not leave any unfastene d sma ll parts inside the
case after installation. Loose parts will cause short
circuits which ma y damage the equipment.
 Keep the computer from dangerous area, such as heat
source, humid air and wate r.
1.2 PACKAGE CHECKLIST
HDD Cable x 1
Se ria l ATA Cab le x 1
Use r’s Manual x 1
Fully Setup Driver CD x 1
Rear I/O Panel for ATX Case x 1
FDD Cable x 1 (optional)
USB 2.0 Cable x 1 (optiona l)
S/PDIF Cable x 1 (optional)
Se ria l ATA Po we r Cab le x 1 (o p tio nal)
Note: The package contents may differ by area or your motherboard version.