Owner's Manual

915GV-M7 DDR2
13
CHAPTER 3: HEADERS & JUMPERS SETUP
3.1 HOW TO SETUP JUM PE RS
The illustration shows how to set up jumpers. When the jumper cap is
placed on pins, the jumper isclose”, if not, that means the jumper is
open”.
Pin opened Pin closed Pin1-2 closed
3.2 DETAIL SETTINGS
JUSBV1/JUSBV3_1: Power Source Headers for USB Ports
Pin 1-2 Close:
JUSBV1 : +5V for USB ports at back panel (JRJ45USB1/JUSB2).
JUSBV3_1 : +5V for USB ports at f ront panel (JUSB3/JUSB4).
Pin 2-3 Close:
JUSBV1 : USB ports at back panel (JRJ45USB1/JUSB2) are powered by
+5V standby voltage.
JUSBV3_1 : USB ports at front panel (JUSB3/JUSB4) are powered by +5V
standby v oltage.
1
3
31
Pin 1-2 Close (default)
JUSBV1
3
1
JUSBV3_1
13
1
3
31
Pin 2-3 Close
Note:
In order to support this f unc tionPower-On s ys te m via U SB device,JUSBV1/
JUSBV3_1” jumper cap should be placed on Pin 2-3 indi viduall y.