Owner's Manual

915GL-M7 Ultra
12
CHAPTER 3: HEADERS & JUMPERS SETUP
3.1 HOW TO SETUP JUM PERS
The illustration shows how to set up jumpers. When the jumper cap is
placed on pins, the jumper is “close”, if not, that means the jumper is
“open”.
Pin opened Pin closed Pin1-2 closed
3.2 DETAIL SETTINGS
JKBV1: Power Source Header for PS/2 Keyboard and Mouse
Assignment Description
1
Pin 1-2 close
+5V +5V f or PS/2 key board and mouse
1
Pin 2-3 close
+5V Standby
Voltage
PS/2 mouse and keyboard are
powered with +5V standby v oltage.
Note:
In order to support this function “Power-on system via keyboard and
mouse”, “JKBV1/JUSBV1/JUSBV3_1” jumper cap should be placed
on Pin 2-3.
JUSB V1/JUSBV3_1: Powe r Source Heade rs for USB ports
Assignment Description
1
Pin 1-2 close
+5V
JUSBV1: +5V for USB ports at
JRJ45USB1 & JUSB2.
JUSBV3_1: +5V for JUSB3/JUSB4.
1
Pin 2-3 close
+5V Standby
Voltage
JUSBV1: USB ports at JRJ45USB1
and JUSB2 are powered by +5V
standby v oltage.
JUSBV3_1: JUSB3/4 are powered by
+5V standby voltage.
Note:
In order to support this function “Power-on system via keyboard and
mouse”, “JKBV1” jumper cap should be placed on Pin 2-3.