User's Manual

Detecting a Fall
In the case of a fall detected automatically, the LED will turn on, and a fall alert
message will be transmitted.
Sending Heartbeat Messages
AP001V2 sends heartbeat messages every hour. These messages contain the
accumulated activity information, with values determined by the number of steps.
Sending Panic Signal
To send a panic signal, press and release the button. The LED should turn on upon
release, and a message will be transmitted to indicate the panic.
Clearing Alarm
To clear an alarm and turn off the LED, press and hold the button until the LED turns off,
which will take approximately 10 seconds. This will transmit a clear alarm message.
The LED will turn on and remain on after sending a fall or a panic signal. Sending a
clear alarm signal will turn the LED off.
Specifications
 Dimension: 2.165” x 1.468” x 0.603”
 RF Transmission Frequency: 345 MHz
 Operating Temperature: -10ºC to 60ºC
 Battery Type: CR2450 Lithium
 Battery Life: 1 year
 Battery Voltage: 3.0V
 FCC ID: 2AA5H-AP001V2
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.