User's Manual

Page 5

Steps in a comprehensive installation

Every installation is unique. In some cases, the issues are well understood and can

be handled in a standard fashion. In other cases, there are issues that are specific

to the installation, and may not be immediately recognizable. This document

attempts to address many of the issues that you will be faced with during

installation. The steps for a successful installation are:

Ø Planning the installation – outlining the different components in the

installation, determining the interconnections between different

components, identifying issues specific to the installation

Ø Component selection – deciding on the right Veri-Series product(s) to use,

choosing a door controller, which type of proximity or smart cards to use,

which type of PC to use (optional, except for V-Pass), etc.

Ø Mounting – proper mounting hardware and location must be chosen in

accordance with applicable regulations as well as desired esthetics and

convenience

Ø Power Distribution / Device hook-up – proper power must be supplied to

each unit and consideration must be given to using UPS, avoiding

interference, proper grounding, etc.

Ø Cabling and Interconnection issues – the topology, type of network, and

type of cable used will be determined by requirements such as number of

units, distance between units, data throughput, etc. Each device on the

network must be assigned a unique ID (and IP address for Ethernet) to avoid

communication collisions

Ø Power-up procedure – units should be brought up one at a time in a

thoughtful sequence to help trouble-shoot any problem areas

The following sections will provide more information on each of these steps.

WARNING WARNING

Veri-Series devices must be installed by a qualified technician.