User manual

Programming the Basic Settings

In general, all settings of your BionX electric propulsion system are pre-set. Basic display functions can

be set by entering the programming mode. Contact your dealer to customize the advanced functions of

your system.

Turn on the programming mode

Simultaneously push and until the display shows “0000”. The ﬁrst zero blinks. Change the value

of the selection with or and conﬁrm with . Select the other digits in the same manner until the

desired program is displayed.

Note: For G1 programming, substitute (mode) and (crono) for (power) and (cycle)

respectively, and remain the same.

Code Description

2001 Select km/h or mph

2002 Regeneration/brake output (for reed switch) 0-40 (ideally 30-40)

2004 Clock adjust

2005 Tire circumference (millimeters)

2009 Flip Display: 0 = power left, 1 = power right (G2 only)

Code 2001 Code 2002 Code 2004

Select unit - km/h or mph. Select with

or , and conﬁrm with .

Default value: 30. Change with

and

. Conﬁrm with .

Select hour/minutes with

change value with

and .

Conﬁrm with

Code 2005 Code 2009

Set tire size (in mm) - Select digits

one after another with

or , and

conﬁrm with

Current setting of main functions is

displayed. Flip = 0, assist toggle is

the right side of console; Flip = 1,

assist

toggle is on the left side of console.

Conﬁrm with

WARNING

Do not use other programming codes without consulting your authorized dealer.

If you type the wrong code, please push the key to exit programming mode.

english