User manual

Power Supply

48V battery charging procedure (power supply)

• Connect the power supply and the battery by

inserting the charge connector into the TOUCH PORT

– the BionX system can be on or off

• Connect the power supply to a power receptacle

• The battery TOUCH PORT (LED ring around the

charge connector) lights up red upon insertion and

then turns to amber during the charging process

• When fully charged, the colour of the LED ring

changes to green. The battery charging process is

then complete

• Following this procedure the charging connector should be disconnected from the battery

• During the charging process you can check the battery state-of-charge through the console if the

battery is connected to the system – a 48V system can be switched on while it is charging

This has my vote :)

Battery state-of-charge Colour

100-75 % Green

75-20 % Amber

< 20 % Red

Checking the 48V Battery state-of-charge

• Swipe your ﬁnger slowly over the TOUCH PORT

• Battery state-of-charge LED will illuminate

• Allow ten (10) seconds before checking state-of-charge again

NOTE

The power supply is suitable for line voltage ranges of 110-115V or 220-230V, and com-

pensates automatically. The 48V battery is designed to be charged by a 26V BionX power

supply. The battery has an integrated charger which permits the use of a small, portable

power supply.

Ensure that a completely charged battery is no longer connected to the power supply after the charge

procedure is completed.

TOUCH PORT green =

fully charged

TOUCH PORT amber =

charging

TOUCH PORT red =

upon insertion

english