Operation Manual

BEFORE ANY RIDE - Make sure the connections are all adequately
plugged in;
- Look for a full battery charge level on your LCD
command console. If this is not the case, please refer to the “how to charge the battery” section (page 20);
- Always make sure your battery is well fastened
to the frame and locked.
FLAT TIRE Simply disconnect both connectors that are covered with a neoprene (rubber girdle) near the rear wheel. You can remove the BionX wheel like any conventional wheel. In case of problem, please see your retailer. WARNING : Before plugging or unplugging the motor, double-check that your system is turned OFF. (controller is off)
HOW TO BRING THE BEST OUT OF YOUR BIONX SYSTEM Use the assistance levels according to your needs. Always remember that your BionX is still a bicycle and should be used as such. Look for opportunities to use the recharge modes. If you are going downhill or riding with a back wind, it is sensible to put the bike in recharge mode by pressing the G– button or by braking.
22