User's Manual

Copying a Record for an Existing Patient to an Unassigned System
Follow these instructions when a patient has a record stored in the clinician programmer database
and no patient data have been stored on the EPT or patient programmer, i.e., the patient is not
new but the patient’s system is unassigned. This patient may have purchased replacement
components, or the patient’s components may have been reset.
To copy a record for an existing patient to an unassigned system:
1.
Make certain that the clinician programmer is connected to an operational patient
programmer and EPT. See “Set-Up Instructions” section of this guide.
If the EPT and patient programmer are unassigned, the StimRouter application should
automatically prompt that no patient data were found on the system. Press “OK.” See
Figure 7-1.
If this prompt does not appear and the patient’s components are new, then reset the
patient programmer and EPT. See “Tools” section of this guide.
Find the patient’s record on the Patient List, and then press “Open.” When the patient
record opens, the patient data will automatically copy from the clinician programmer to
the EPT and patient programmer.
2.
3.
4.
Chapter 7 - Patient Records and History
47