User Manual

110
NESS L300 Plus
User’s Guide
Blank Label
Figure 75: Label on the Gait Sensor for the System ID Number.
6. After registration is complete, turn on the system and select gait mode.
Press and release the pressure sensor. If the new Gait Sensor is registered,
the mode button will flash YELLOW rapidly for four seconds.
7. Locate the System ID Number on the NESS L300 Plus carrying case (for
example, A334). Write the number on the small label on the back of the
new Gait Sensor. See Figure 75. This number identifies which system
the sensor is registered to.