User Manual

108
NESS L300 Plus
User’s Guide
3. The Control Unit digital display will show two alternating GREEN
arches while registration is in process. Registration should take several
seconds to complete.
4. When registration is complete, (“C” for complete) will appear in the
digital display and the RF Stim Unit indicator will turn GREEN for a few
seconds. The Control Unit will beep.
5. If (“E” for error) appears in the digital display, an error has occurred.
Repeat the procedure. ( "E" also can mean that the registration procedure
was successful on a prior attempt and not noticed.)
After registration is complete, turn on the Control Unit. If the new RF Stim Unit
is registered, the RF Stim Unit will turn on. If you see an RF failure indication,
wait 20 minutes for the RF Stim Unit to enter energy-saving mode, and then
repeat the procedure.
Registering a New Gait Sensor
Setup
1. Connect the Control Unit and RF Stim Units to the system charger set
during registration.
2. Place the new Gait Sensor, FS Cuffs with RF Stim Units, and Control Unit
close together on a table but not touching. See Figure 74.
3. Make sure all other NESS L300 Plus System components (including the
used Gait Sensor in your shoe) are at least 30 feet from the components
you are registering.