User Manual

107
Chapter 10 - Electronically Registering New Components
1. Place the FS Cuff with the attached new RF Stim Unit, the other FS Cuff
with attached RF Stim Unit, the Control Unit, and the Gait Sensor close
to each other on a table but not touching.
2. Make sure all other NESS L300 Plus System components are at least 30
feet from the NESS L300 Plus components you are registering.
Registration
1. Make sure the Control Unit has been off for 20 minutes, and that the RF
Stim Units are in energy-saving mode.
2. Simultaneously press and hold for three seconds the mode and
minus buttons on the Control Unit. The Control Unit will beep when
registration begins. See Figure 73.
Figure 73: Registering a new RF Stim Unit.
Press and hold the
mode and minus
buttons for three
seconds.
New
Unregistered
RF Stim Unit