User Manual

101
Chapter 9 - Component Maintenance and Cleaning
Removing the RF Stim Units
The only time you should remove an RF Stim Unit is to clean the FS Cuff or
replace the RF Stim Unit.
To remove the RF Stim Units:
1. Turn off the Control Unit.
2. Pull the top of the RF Stim Unit away from the cradle. See Figure 68. If
the fit is too tight, open the flexible cover over the RF Stim Unit charging
port for a better grasp.
3. Remove the bottom of the RF Stim Unit from the cradle.
Figure 68: Removing the RF Stim Unit.
Cradle
RF Stim Unit
Inserting the RF Stim Units
To insert the RF Stim Units:
1. Insert the bottom of the RF Stim Unit into the cradle. Then, gently push
the top of the RF Stim Unit into the cradle until it snaps in.