User Manual

93
Chapter 9 - Component Maintenance and Cleaning
3. If necessary, clean the cloth electrode bases with a damp cloth. Do not
use a chemical-based cleaning substance.
4. Wet the new cloth electrodes with tap water until they are saturated. See
Figure 56.
5. With a soft cloth, gently wipe or blot excess water off the back (side with
the snap) of the cloth electrodes. See Figure 57.
6. Attach the L300 cloth electrodes to the L300 cloth electrode bases. See
Figure 58.
Note: Remove and re-wet the cloth electrodes every time you remove the
L300 FS Cuff from your leg for more than one hour, and after every four hours
of use. When wetting the cloth electrodes, always remove them from the L300
FS Cuff. If the cloth electrodes dry out, your response to the stimulation may
change. If you need to adjust stimulation intensity more often than usual, try
re-wetting the cloth electrodes following the steps listed above.
Figure 56: Wetting the cloth electrodes.