User Manual

68
NESS L300 Plus
User’s Guide
3. Point the wire of the pressure sensor toward the toe of the shoe. Then,
attach the pressure sensor to the Gait Sensor pad. See Figure 37. Refer
to the foot image on the pressure sensor for positioning.
4. Cover the inner clamp on the transmitter with the shoe spacer, if desired.
See Figure 38. The teeth of the clamp may scuff the shoe, if not covered.
Figure 38: Covering the clamp with the shoe spacer.
Foot Image on
Pressure Sensor
Gait Sensor Pad
Shoe
Spacer
Inner Clamp
Figure 37: Positioning the pressure sensor in the shoe