Use Instructions
Version: BBN-LBL-IFU-FULL Rev. 0.5 5
Replace Your Adhesive
• When no longer sticky.
• If you experience redness or irritation in the placement area.
REMOVE adhesive from bottom of device. Follow steps 4 through 6 to put on a new adhesive and
reapply BioButton.
When replacing the adhesive, it is advised to apply the device to a dierent location within the placement area.
Troubleshooting and FAQs
Can I shower or exercise with my device?
Yes, the BioButton is water resistant and can be worn during showers and exercise. Do not apply any deodorant
or lotion to the placement areas as it will reduce adhesion of the device to the skin.
Can I swim or bathe with the BioButton?
Yes, the BioButton is water resistant and will continue working as long as it is not submerged more than 3 feet
or kept underwater for longer than 30 minutes at a time. Prolonged exposure to water may cause the device to
loosen from the skin.
I’m experiencing some skin irritation, what should I do?
Minor skin irritation and itching may occur while wearing the BioButton. If a severe reaction develops (i.e. hives
or blisters), discontinue wearing and immediately contact your physician.
How long should I wear my device?
Please wear your device for the entire monitoring period period, but no longer than 90 days. Each adhesive
may be worn for up to 7 continuous days. You may replace the adhesive more often, as needed, to ensure good
contact is maintained with the skin.
How do I know my device is working?
Press and release BioButton’s button. The device light will blink 4 times. If the device does not blink or blinks
more than 4 times, please immediately contact Customer Support (see front cover).
I’ve tried activating the device several times, and the light still won’t blink. What do I do?
Contact Customer Support immediately (see front cover). You may be instructed to return the device and may
receive a replacement kit if more data is needed for the monitoring period.