User's Manual

The configuration of the measured value
memory can be found after the time setting
in the settings menu sequence.
Step 5:
Press the SET button again: Now the display
for the day starts blinking.
Step 6:
Press the MEM button until the correct day is
displayed.
Step 7:
Press the SET button again: Now the display
for the hours starts blinking.
Step 8:
Press the MEM button until the correct hour
is displayed.
Step 11:
If you do not wish to make any further set
-
tings, exit the settings menu by pressing the
On/Off button. Otherwise, continue with the
settings by pressing the SET button.
3.5 Configuring the measured value
memory
(applies only for the BPM205
device (without wireless interface))
Note:
The blood pressure meter stores the measured
blood pressure and pulse values. The measured
value memory can be set so that the measure
-
ments can be allocated to 8 different users.
To do this, the measured value memory must
be enabled for the individual users in the
settings menu.
– In its delivered condition, the measured
value memory is only enabled for one user
(“User 1”).
Step 9:
Press the SET button again: Now the display
for the minutes starts blinking.
Step 10:
Press the MEM button until the correct
minute is displayed.
Getting started
3
18 19