User's Manual

52 53
EMC information
The wireless module integrated in this device
(BPM105 only) fulfills the regulations of EC
directive 1999/5/EC (Radio and
telecommunication terminal equipment,
R&TTE).
The requirements of the following standards
are met:
– ETSI EN 301 489-17 Electromagnetic
Compatibility and Radio Spectrum
Matters (ERM); Electromagnetic
Compatibility (EMC) Standard for Radio
Equipment and Services; Part 17: Specific
Conditions for 2,4 GHz Wideband
Transmission Systems
– EN 300328-2 V1.2.1 Electromagnetic
compatibility and radio spectrum
– FCC Class B Part 15
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful
interference and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the
manufacturer’ instructions, may cause
interference harmful to radio
communications. There is no guarantee,
however, that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
equipment and receiver
– Connect the equipment to an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced
radio or TV technician for help.
Not authorized changes or modifications
could void authority to use this equipment.