User's Manual

22 23
Step 1:
To reset the wireless interface, keep pressing
the SET button until the radio symbol at the
bottom left of the display (= fat black dot in
double-parentheses ) starts to blink. To the
right of the radio symbol appear two “0”s.
If there is no dash between the two “0”s, this
means that the wireless connection is reset.
If there is a dash between the two “0”s, this
means that the wireless connection is main
-
tained.
Step 2:
To switch between maintaining and reset-
ting the wireless connection, press the MEM
button.
Step 3:
If you are finished making settings, you can
exit the settings menu by pressing the On/Off
button. Otherwise, continue making settings
by pressing the SET button.
2.8 Clearing the measured value memory
The operation for clearing the measured
value memory is the last item in the settings
menu.
Step 1:
In order to clear the stored blood glucose val
-
ues from the measured value memory, press
the SET button until the word “mem” starts
blinking on the right side of the display.
Step 2:
When you press the MEM button, “CLr”
(clear) appears at the bottom of the display
(means that the memory will be cleared).
Remark:
When the abbreviation “CLr” appears on the
display and you switch off the device via the
On/Off button or by pressing the SET button,
the entire measured value memory is cleared.
If you do not wish to clear the values, press
the MEM button again to make “CLr” disap
-
pear.


Getting started
2