User's Manual

13
Step 3:
Remove any used batteries and dispose of
them properly in accordance with the valid
regulations.
Step 4:
Insert the two 1.5 V alkaline batteries accord-
ing to the symbols in the battery compartment.
Step 5:
Replace the battery compartment cover and
click the fastening device into place.
Step 6:
Afterwards, check whether the battery has
been correctly inserted by briefly pressing the
START button. If this is the case, all display
elements appear for about two seconds as a
function test.
Notes:
- Remove the batteries if you don't use the
body scale for some time. Use only AAA
1.5V batteries in this device. Replace
batteries periodically.
- Please make sure that you always have a
replacement battery on hand
- New batteries (1.5 V alkaline batteries
- [type AAA/LR03]) have a lifetime of more
than 18 months at 5 measurements per
- day.
- When the batteries are exchanged and
when the scale is stored without batteries,
the contents of the measured value memory
are retained.
- When the batteries are removed, the
internal clock of the measuring device
doesn’t continue to run, so when the device
is used again after exchanging the batteries
or after storing the device without batteries,
the date and time may have to be reset
(see Section 3.4)
For the sake of environment:
Used batteries are hazardous waste and
should not be thrown in the household
g
arba
g
e can.
WARNING: Ensure that batteries are
inserted with the correct polarity.
Improper installation is a hazard.
WARNING: If battery fluid should get in
your eye, immediately rinse with clean
water and contact your physician!