User Guide

INSTRUCTIONS FOR USE
For complete instructions, visit:
BioIntelliSense.com/support
CHARGE the BioButton device
with provided charging cable
(see below to correctly attach).
The indicator light will BLINK
when device is charging.
1
GET STARTED
TAKE one adhesive. Peel
the backing from DEVICE
SIDE of adhesive.
8
Place the BIOBUTTON on
the exposed adhesive. Turn
the device over and remove
remaining adhesive backing.
9
P
R
E
S
S
D
O
W
N
ADHERE the BioButton
Rechargeable device to the
upper left chest placement
area near the sternum. Apply
pressure for 15 SECONDS.
10
Press the button to check the
device status. See Button
Light Pattern guide below.
11
Locate placement area on
UPPER LEFT CHEST, two
inches below collar bone, and
close to the sternum.
6
PATTERN MEANING
10 blue blinks Not Activated
Continuous slow
blue blinking
Updating
Firmware
4 green blinks
Actively
Monitoring
5 orange blinks Low Battery
Solid red light
or no light
Error detected,
contact support
Charging
contacts
Button
Indicator
light
DEVICE
+
COMPONENTS OVERVIEW
®
CHARGING CABLE ADHESIVES
CLEANSE AREA with a warm,
damp cloth. Note: TRIM ANY
BODY HAIR using only an
electric trimmer.
7
NO RAZORS NO WAXING NO ALCOHOL
5
CONFIRM BIOBUTTON
ACTIVATION by pressing the
button and verifying that the
light blinks GREEN 4 TIMES.
If the blink pattern is dierent or
the light does not blink, refer to
the Button Light Pattern guide
after step 11 for guidance.
Note: Device may perform
a rmware update before
activation. If so, the light will
slowly blink blue for
a few minutes.
FULLY INSERT
CORRECT
POWERED
INCORRECT
2
Proceed when the indicator
light turns SOLID GREEN,
indicating a full charge.
LIGHT PATTERNS WHILE CHARGING
PATTERN CHARGE LEVEL
Blink orange 0% - 10%
Blink yellow 11% - 70%
Blink green 71% - 99%
Solid green 100%
DISCONNECT charging cable
and PRESS the button. The
light will blink BLUE 10 TIMES
after the device has powered
on. (Note: the device may take
up to 15 seconds to power on)
3
LIGHT
PRESS &
HOLD
ACTIVATE your BioButton
Rechargeable device with
the designated APP or
HUB DEVICE indicated in your
program’s instructions.
4

Summary of content (2 pages)