BIO BIDET®AS A Installation Please make sure you read the instructions carefully and install it property. BE Caution 1. The water pressure mil is from 10 to 110 PSI, Please use as instructed. 2, The water shutoff valve should be near whets the product is installed. BE Product Installation Procedure B@ Pr-installation 1. Insert the mounting bolls info the 2. Insert the mounting bolts with the rectangular steel mounting brackets. brackets info the catch plate. \. , 3.
BIO BIDET®As Installation Procedure ¢ First installation method (recommended) ’ 1. Completely remove the old toilet seat & lid install expansion nuts. Be sirs fo firmly press down so the top of the expansion nut is flush with the ceramic toilet surface. \ ’ 3. Altach the catch plate + Attach the catch plate In the tolls seat holes. Adjust the position of mounting bolts and adjusting pieces to line up the mounting bolts to the expansion nuts. Then tighten to secures the catch plate.
BIO BIDET®AS Eighteens ies es 1. Close the water supply valve. Flush FOFL. ~ 2. Unscrew water supply hose from water tank, Place towel below tank fo catch any dripping whet. ~ 3. Using finger nut, attach T-Valve to water tank where you removed the water supply hose. 4. Re-aitch water supply hose to bottom of Velvety. 5. Connect the bidet supply hose to the metal infer on the side of the bide! seat. Connect ihe other end of the hose to the T-Valve and tighten snugly. Be careful nol fo over-tighten. 8.
