HD-4000 User Manual
TABLE OF CONTENTS PRODUCT INFORMATION Features............................................................................5 Parts.....................................................................................6 Dimensions....................................................................7 PRODUCT INSTALLATION Pre-Installation............................................................8 Installation......................................................................9 PRODUCT OPERATION How To Use...
FEATURES • Tilted control panel • High-quality ABS material • Premium quality metal inlet and installation parts • Dual nozzle • Ambient temperature bidet wash • Adjustable water pressure • Unified internal brass valve • Durable braided metal cold water hose • No electricity or batteries required • Adjustable toilet fit • One-year warranty 5
DIMENSIONS 2.48 in 3.23 in 0.24 in Bidet attachment 2 Adjustable mounting brackets 3.54 in PARTS 12.79 in 15.73 in *T-Valve connector with rubber cone washer (7/8” x 7/8” x 3/8”) 8.65 in 4.32 in 12.37 in 2 Non-slip mats 5.49 in 27.5” Braided metal hose Teflon tape 3 Toilet bumpers 2.87 in *Alternate fittings available, contact support@biobidet.
PRE-INSTALLATION Please be advised that the provided T-Valve should be installed at the fill valve under the toilet tank, NOT down at the water supply coming from the wall. INSTALLATION 1. Remove the existing toilet seat by locating the bolts and nuts, typically under a plastic cover, and removing them first. 2. Close the water supply valve and flush the toilet completely so that there is little to no water left in the toilet tank. 3. Disconnect the water hose from underneath the toilet tank. 4.
INSTALLATION (CONT.) 5. Attach the water supply hose that comes from the water shut off to the bottom of the T-Valve. 6. Connect the metal hose we supplied to the open side of the T-Valve. 9. Place the bidet on the toilet with the mounting brackets over the bolt holes and make any needed adjustments to make sure the bidet is centered on the toilet. 10. Place the toilet seat back on the toilet over the bidet and secure the bolts down so that the seat and bidet attachment are stable. 7.
INSTALLATION (CONT.) HOW TO USE For back wash, turn the control dial to the left towards the “ “ position. For front/feminine, turn the control dial to the right towards the “ “ position. 13. After installing your bidet attachment, check to see if there is a gap between the toilet base and toilet seat. 14. If necessary, place the bumpers on the underside of your toilet seat as indicated above. The further the knob is turned, the higher the water pressure will be.
CLEANING WARRANTY Your Bio Bidet is warranted against defects in materials or workmanship for 1 year Your HD-4000 is made with a high grade fire-retardant ABS resin. Using hard cleaning chemicals can weaken the material, causing it to damage and develop cracks. 1. Clean the HD-4000 by wiping the surface area with a damp cloth regularly. 2. Do not use harsh detergents or any cleaning tools with bristles on your bidet. Steam cleaning is the preferred cleaning method for your bidet.
Thank You Technical Support/Customer Service 7900 S Route 31 Crystal Lake, IL 60014 T: 847.458.2334 U.S TOLL FREE: 877.339.5214 support@biobidet.com www.biobidet.
