Product Label

Read and follow all label directions.
This product will kill or injure all listed woody plants contacted. Certain warm
season grasses may experience temporary yellowing when sprayed to excess.
• If a desirable plant (other than grass) is accidentally sprayed, immediately rinse
with plenty of water.
• Apply when wind is calm.
• Keep people and pets off treated areas until spray has dried.
RESTRICTIONS
• Do not apply to or around fruits or vegetables used for food.
DIRECTIONS FOR USE It is a violation of Federal law to use this
product in a manner inconsistent with its labeling.
BEFORE USE
TIPS:
• Use a sheet of cardboard or plastic to protect desirable plants from accidental
contact with the product.
• To Kill Vines
- For vines growing on desirable plants, cut the vine and spray the stump.
• To Kill Poison Ivy or Poison Oak
- Contact with Poison Ivy or Poison Oak anytime of the year can cause an allergic
reaction. Handle dead plants with rubber gloves.
- Dispose of plants and gloves in tightly sealed garbage bags.
This bottle may be refilled when empty.
Refilling the 1.3 gallon sprayer from the BioAdvanced® Science-Based
Solutions Extended Control Brush Killer Ready-To-Use package.
• Open refill port cap.
• Fill bottle with desired amount, using with desired ready-to-use product.
• Replace refill port cap, tighten and shake well.
REFILL
• Apply when listed weeds are fully leafed out and actively growing.
• Apply the product until plant is thoroughly covered (first drip).
• Rain or water 4 hours after application will not wash away effectiveness.
• Certain listed hard-to-kill weeds may require a repeat application.
• If regrowth occurs, apply again 30 days or more after the initial application.
FOR BEST RESULTS
Shake Well Before Use.
• Shake well before using.
• Adjust sprayer nozzle to give a coarse spray.
• Hold sprayer about 12" from brush or weeds .
• Spray the brush/weeds you want to kill until thoroughly wet but not dripping.
Remove ERGO-GRIP
®
spray wand from pocket.
Remove protective battery strip from sprayer handle.
HOW TO USE
OPEN SPRAY WAND
• Unfold spray wand until it snaps into place.
• Point spray nozzle away from body.
• Adjust spray nozzle to desired setting.
TURN POWER ON
• Slide OFF-ON switch to ON position.
SQUEEZE
• Squeeze trier to dispense product. Sprayer may require several
seconds to prime before product is released.
• Release trier to stop spraying.
CONNECT HOSE TO CAP
• Remove wrap from coiled hose.
• In down position, insert plug at end of hose into flip-spout opening
on the cap until it snaps into place.
• Flip up spout until fully upright. Spout must remain upright while
spraying.
STORAGE
• Slide OFF-ON switch to OFF position.
• Return flip spout on cap to the down position. Do not unplug hose. Turn spray nozzle
to the off position.
• Fold spray wand down against sprayer handle.
• Return ERGO-GRIP® spray wand to pocket for storage.
• 4 AA Batteries Included
• For important battery information see booklet.
TO REPLACE BATTERIES
• Open battery compartment with a small screwdriver.
• Remove used batteries and replace with new batteries in correct position as indicated
inside battery compartment.
• Securely close battery compartment door and screw closed.
PROPER USE OF BATTERIES
• Never mix old batteries with new.
• Do Not mix Alkaline with Standard (carbon zinc) or Rechargeable (nickel cadmium)
batteries.
• When storing sprayer for long periods, remove batteries to prevent leakage. Dispose
of used batteries according to manufacturer's instructions or in household trash.