Instructions / Assembly

The requirements in this box apply to uses of this product that are NOT within the scope of the Worker Protection Standard for agricultural pesticides
(40 CFR Part 170). The WPS applies when this product is used to produce agricultural plants on farms, forests, nurseries, or greenhouses. The application
for trimming and edging, industrial, recreational and public areas, and farmsteads are not within the scope of the WPS.
POLLINATOR ADVISORY This product contains an herbicide. Follow all label directions and precautions to minimize potential off-target exposure in
order to prevent effects to non-target plants adjacent to the treated site which may serve as habitat or forage for pollinators.
SPRAY DRIFT MANAGEMENT The interaction of many equipment and weather-related factors determines the potential for spray drift. The applicator
is responsible for considering all these factors when making application decisions.
Wind: Drift potential increases at wind speeds of less than 3 mph (due to inversion potential) or more than 10 mph. However, many factors including
droplet size and equipment type determine drift potential at any given wind speed.
AVOID APPLICATIONS DURING GUSTY OR WINDLESS CONDITIONS.
Note: Local terrain can influence wind patterns. Every applicator needs to be familiar with local wind patterns and how they affect spray drift.
Temperature and Humidity: When making applications in hot and dry conditions, set up equipment to produce larger droplets to reduce effects of
evaporation.
DIRECTIONS FOR USE It is a violation of federal law to use this product in a manner inconsistent with its labeling.
DO NOT use this product until you have read the entire label. DO NOT apply this product in a way that will contact workers or other persons, either
directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult
the agency responsible for pesticide regulation.
In the State of New York Only: Not For Use in Nassau and Suffolk Counties.
NON AGRICULTURAL USE REQUIREMENTS
• DO NOT apply when wind speeds exceed 10 miles per hour at the application site. • DO NOT apply during temperature inversions.
MANDATORY SPRAY DRIFT MANAGEMENT
When applied as specified in this label, this product controls annual and perennial weeds. Refer to the How to Apply section of this labeling for specified
rates and a list of weeds controlled. Applications may be made on a broadcast, banded or spot treatment basis depending on the situation. Avoid direct
spray or drift to desirable vegetation. Regrowth may occur due to the weed stage of growth at application, low use rate, or environmental conditions.
Repeat treatments may be necessary to control plants generating from underground parts or seed.
NONCROP USES
This product is a foliar-active material. Best results are obtained when weeds are actively growing. Weed control may be reduced when applications are
made to weeds under stress due to drought or cool temperatures. Weeds under stress or in dense populations will require application of the highest
rate specified. Refer to the How to Apply section of this label.
This product must be applied at the rate specified in the How to Apply section of this label. Repeat applications of this product will be needed to
control weeds emerging from underground parts or seeds.
WHEN TO APPLY
This product must be mixed with water to make a finished spray solution as follows:
1. Fill the spray tank with the required amount of water. 2. Add the proper amount of this product, then mix thoroughly.
HOW TO MIX
ADVISORY SPRAY DRIFT LANGUAGE
Temperature Inversions: Drift potential is high during a temperature inversion. Temperature inversions restrict vertical air mixing, which causes small
suspended droplets to remain close to the ground and move laterally in a concentrated cloud. Temperature inversions are characterized by increasing
temperature with altitude and are common on nights with limited cloud cover and light to no wind. They begin to form as the sun sets and often continue
into the morning. Their presence can be indicated by ground fog; however, if fog is not present, inversions can also be identified by the movement of
smoke from a ground source or an aircraft smoke generator. Smoke that layers and moves laterally in a concentrated cloud (under low wind conditions)
indicates an inversion, while smoke that moves upward and rapidly dissipates indicates good vertical air mixing.