Instructions / Assembly

The requirements in this box apply to uses of this product that are NOT within the scope
of the Worker Protection Standard for agricultural pesticides (40 CFR Part 170). The
WPS applies when this product is used to produce agricultural plants on farms, forests,
nurseries, or greenhouses. The application for trimming and edging, industrial,
recreational and public areas, and farmsteads are not within the scope of the WPS.
POLLINATOR ADVISORY This product contains an herbicide. Follow all label directions
and precautions to minimize potential off-target exposure in order to prevent effects to
non-target plants adjacent to the treated site which may serve as habitat or forage for
pollinators.
SPRAY DRIFT MANAGEMENT The interaction of many equipment and weather-related
factors determines the potential for spray drift. The applicator is responsible for
considering all these factors when making application decisions.
Wind: Drift potential increases at wind speeds of less than 3 mph (due to inversion
potential) or more than 10 mph. However, many factors including droplet size and
equipment type determine drift potential at any given wind speed.
AVOID APPLICATIONS DURING GUSTY OR WINDLESS CONDITIONS.
Note: Local terrain can influence wind patterns. Every applicator needs to be familiar
with local wind patterns and how they affect spray drift.
Temperature and Humidity: When making applications in hot and dry conditions, set
up equipment to produce larger droplets to reduce effects of evaporation.
Temperature Inversions: Drift potential is high during a temperature inversion.
Temperature inversions restrict vertical air mixing, which causes small suspended
droplets to remain close to the ground and move laterally in a concentrated cloud.
Temperature inversions are characterized by increasing temperature with altitude and
are common on nights with limited cloud cover and light to no wind. They begin to form
as the sun sets and often continue into the morning. Their presence can be indicated by
ground fog; however, if fog is not present, inversions can also be identified by the
movement of smoke from a ground source or an aircraft smoke generator. Smoke that
layers and moves laterally in a concentrated cloud (under low wind conditions) indicates
an inversion, while smoke that moves upward and rapidly dissipates indicates good
vertical air mixing.
DIRECTIONS FOR USE It is a violation of federal law to use this
product in a manner inconsistent with its labeling.
DO NOT use this product until you have read the entire label. DO NOT apply this product
in a way that will contact workers or other persons, either directly or through drift. Only
protected handlers may be in the area during application. For any requirements specific
to your State or Tribe, consult the agency responsible for pesticide regulation.
In the State of New York Only: Not For Use in Nassau and Suffolk Counties.
NON AGRICULTURAL USE REQUIREMENTS
• DO NOT apply when wind speeds exceed 10 miles per hour at the application site.
• DO NOT apply during temperature inversions.
MANDATORY SPRAY DRIFT MANAGEMENT
When applied as specified in this label, this product controls annual and perennial weeds.
Refer to the How to Apply section of this labeling for specified rates and a list of weeds
controlled. Applications may be made on a broadcast, banded or spot treatment basis
depending on the situation. Avoid direct spray or drift to desirable vegetation. Regrowth
may occur due to the weed stage of growth at application, low use rate, or environmental
conditions. Repeat treatments may be necessary to control plants generating from
underground parts or seed.
NONCROP USES
ADVISORY SPRAY DRIFT LANGUAGE