Owner's manual
Table Of Contents
- CFX Automation System II Installation
- Using the CFX Automation System II
- Starting an Automation Run
- Adding Plates after Starting an Automation Run
- Canceling an Automation Run
- Pausing or Canceling a Single Plate Run in a CFX System
- Emptying the Waste Rack
- LIMS Information
- PrimePCR Information
- Create the Plate List: Additional Features
- Barcode Controls: Advanced Features
- Modify Settings
- Status Tab
- History Tab
- Resources
- Ordering Information
Chapter 1: CFX Automation System II Installation
| 7CFX Automation System II | 7
1. Place bubble level in the center of the CFX System(s) block (Figure 6). Note where the
bubble is within the level.
2. Lift the plate handler arm up high enough to access the tower opening. Place the level
inside the center of the plate handler tower (Figure 7). Compare the position of the
bubble to its position when placed on the CFX System block. Because the CFX Systems
do not have leveling feet, the most important thing is to level the plate handler relative
to the CFX System(s).
■n
If the bubble position differs significantly in the plate handler tower and CFX System(s),
proceed to step 3
■n
If the bubble position does not differ significantly when placed in the plate handler tower
and CFX System(s), proceed to step 6
Fig. 6. Bubble level in CFX System block.
Fig. 7. Bubble level in tower.