User Manual

2.1 INSTRUMENT CONTROL MODULE (ICM): FOR USE WITH THE DUOFLOW ONLY
The ICM translates the signal from the QuadTec detector and transmits it to the BioLogic DuoFlow
workstation. The ICM contains the following:
Front View
• Address setting: The dial should always be set to position 1
• Instrument bus connector: This connector is for System Cable 17 which connects to the BioLogic
Workstation and the Model 2128 Fraction Collector if used. (Refer to Figure 2-3.)
Rear View
• Serial Comm connector: This connector is for system cable 25 (QuadTec RS232 cable), which
connects to the QuadTec detector
• Power connector: This connector connects to the BioLogic DuoFlow workstation DC outlet with
system cable 26
Figure 2-2. Instrument Control Module (ICM) (front and rear views)
USE WITH THE BIOLOGIC DUO-FLOW SYSTEM SYSTEM INSTALLATION AND SETUP
2-2
INSTR. BUS INSTR. BUS
DEVICE
NUMBER
0
1
2
3
4
5
6
7
COMM
RX
TX
POWER
ON
9...25 V
0.3A MAX
_ _ _
FRONT VIEW REAR VIEW