Software Upgrade

Exporting Data to Bio-Plex Manager 6.x
User Guide | 3 9
Exporting Data to Bio-Plex Manager 6.x
Before data can be analyzed in Bio-Plex Manager 6.x, the Bio-Plex Manager MP
run result must first be saved to a file. This file can then be exported to
Bio-Plex
Manager 6.x.
You can export your results in either of the following ways:
 Export your results immediately following a protocol run from the Create/
Run Protocols view. For more information, see
Exporting Data from the
Create/Run Protocols View on page 40.
 Export your results at a later time from the Analyze/Export view. For more
information, see
Exporting Data from the Analyze/Export View on page 41.
Note: You can export your data once the plate reading is completed. If you
select a post-run routine to be run once the run is completed, you do not have
to wait for the routine to complete before exporting your data.
Once the file is saved, it can be viewed in Bio-Plex Manager 6.x in one of the
following ways:
 If Bio-Plex Manager 6.x is installed on the same computer where you are
running Bio-Plex
Manager MP, then you are prompted to view the result in
Bio-Plex
Manager 6.x after the file is saved. If you respond Yes, the result
file is opened in Bio-Plex
Manager 6.x.
 If Bio-Plex Manager 6.x is not installed on your computer, then you must
copy the saved file to a computer where Bio-Plex
Manager 6.x is installed
and import it into the software.