User Manual

From the "Analysis Set with Unfinished Cuts" screen (Figure 6-4):
– Select Resume cut run and finish these cuts and then click Next, to finish cutting an
already defined cut list. Go to Section 6.2, "Setting up a Cut Run".
– Select Change gel assignments and begin new cut run and then click Next to modify the
cut request list (go to "Create a cut request list, above). Note that changes cannot be made
for spots that have already been cut.
•
Cut uncut gels or re-cut previously cut gels
Figure 6-5. Analysis Set with finished Cuts
From the "Analysis Set with Finished Cuts" screen (Figure 6-5)
– Select Create a new cut run of the same spots on different gels and then click Next to
cut previously cut spots from uncut gels in the analysis set (go to "Create a cut request list,
above).
– Select Re-cut existing finished cuts and then click Next to re-cut previously cut spots. Go
to Section 6.2, "Setting up a Cut Run".
5. Select the gels to cut.
•
Manual Gel Selection
ANALYSIS SET EXCISION TOOL
6-3