Specifications

WARNING: To insure proper operation and safety of your water purifier, your unit must be grounded

to a known good ground.

ROUNDING KIT INSTALLATION: BIO-LOGIC

BIO-1.5 P

URE WATER PACK

230V 50/60HZ USING BALLAST NO.10-0504A

1. Ground Kits are shipped with each Bio-Logic

BIO-1.5 Pure Water Pack

230v 50/60Hz water purifier using

ballast 10-0504A and is used to permanently connect a ground wire from the water purifier chamber to a known good

ground.

We recommend checking with local codes or a licensed electrician in your area to determine the best grounding

point to attach the ground kit for your installation. An electrician can also measure the resistance between the water

pipe and an electrical outlet ground to insure your ground selection is correct.

PLACEMENT: Select a location that is visible as well as accessible. Connect the ground strap to a known good ground

or a water pipe that is metallic, with no intervening plastic fittings between it and the power ground.

INSTALLATION: Once a proper ground point has been determined, fasten the ground to the water purifier

chamber as shown and described below.

If you receive a 230v 50/60Hz water purifier, or ballast for a water purifier using ballast No. 10-0504A and a

grounding kit is not present in the carton please contact the factory with your order information and we will send

you the correct grounding kit for your application (35-7300A).

TOOLS REQUIRED

• 7/16" Wrench

• 10mm Wrench or Universal Pliers

• Continuity Tester

Step 2 - Wrap Strap Tight Around Pipe

Step 3 - Insert Bolt Through Both

Copper Holes & Tighten using a 7/16"

Wrench

Step 4

• Insert Wire Into Hole & Install Bolt

• Tighten Bolt against Wire using 10mm

Wrench, Ensure all is Secure

Step 5 - Locate grounding tab

Step 6 -Slide grounding connector

over grounding tab