Owner Manual

Installation & Trial operation
Nuts
Remove the seat from the existing
toilet body.
Remove the water hose and
then install T-valve.
Release the nuts, and then remove the seat and cover
from it.
Keep the removed seat, cover and nuts well in a proper
place in case of using them again.
Turn off the water.
Plug in and be sure that the nozzle
comes out and retracts when
powered on.
Remove the adhesive protection
to attach the remote control
bracket to the wall or other
surface.
Insert two “AA” type batteries
(included) as indicated inside
battery compartment.
Clean the area thoroughly before attaching
the bracket
Identify a location in the bathroom for the
remote control that is visible and reachable
from the toilet.
Align
Fix the bracket onto the toilet
first.
Top mount metal bolt
Top mount rubber nut
Catch plate
Bracket holder
Washer
Push the main body toward the
bracket completely.
Adjust the seat and the front of the toilet back and
forth so that they can line up before fastening
the bolts.
Push it in until it sounds ‘click’
When the product is not installed well, it may cause
leakage.
Don’t plug the power cord with wet hands.
Risk of electric shock.
After installing the T-valve,
connection bidet-use hose to
the bidet body.
Turn on the water and check
for leaks.
Removal of
water hose
Installation
of T-valve