Installation Manual

6 7
INSTALLATION
Remove the existing toilet
1. Close the water shutoff valve
and flush the toilet.
2. Disconnect the existing
water hose and unscrew the
flange bolts.
3. Remove the toilet and wax
ring, leaving the exposed
trap (pictured below).
Install the Prodigy Base
1. Attach the provided
water hose to your water
shutoff valve.
2. Apply the new wax ring to
the exposed trap.
3. Line up the toilet base over
the flange screws. Place the
toilet base and re-secure the
flange bolts.
*if you will not install the
Prodigy immediately,
cover the exposed trap to
eliminate any fumes.
*You may need to use the included
conversion nut to fit your water shutoff
valve. Simply screw the conversion nut
into the 1/2” side of the hose before
connecting it to your water shutoff valve.
*A team of two people is
recommended to correctly
place the toilet base.