PRODIGY INSTALLATION MANUAL
TABLE OF CONTENTS PRODUCT INSTALLATION Before Installing..........................................................4 Parts..................................................................................5 Installation.....................................................................
BEFORE INSTALLING PARTS Confirm the compatibility of your bathroom using the dimensions below: A. What is my rough-in? 12” from the wall to the center of the toilet trap. B. Where is my shutoff valve? Type B1: The shutoff valve will be positioned outside of the toilet base if it is more than 6.25“ from the center of the trap when measured along the wall. Type B2: The shutoff valve will be positioned inside the toilet base if it is less than 5”. C.
INSTALLATION Remove the existing toilet 1. Close the water shutoff valve and flush the toilet. Install the Prodigy Base 2. Disconnect the existing water hose and unscrew the flange bolts. 1. Attach the provided water hose to your water shutoff valve. 2. Apply the new wax ring to the exposed trap. *You may need to use the included conversion nut to fit your water shutoff valve. Simply screw the conversion nut into the 1/2” side of the hose before connecting it to your water shutoff valve. 3.
INSTALLATION (CONT.) Attach Bidet Seat 1. Feed the water hose through the back of the toilet base and attach it to the underside of the bidet seat. Removing The Bidet Seat 1. The bidet seat can be removed by pulling the tabs beneath the unit forward and lifting up. 2. Attach the bidet seat to the toilet base by lining up the mounting hooks and pressing down until you hear a “click.” Do not use excessive force when attaching the bidet seat to the toilet base.
INSTALLATION (CONT.) 1. Open the water shutoff valve. 2. Plug in the power. Contact us Please contact Bio Bidet support if you have any questions. Trained support agents are available Mon - Fri, 9:00 AM - 5:00 PM CST. Email: support@biobidet.com Phone: 847.458.2334 Chat: www.biobidet.com *The Prodigy must be plugged into a properly installed and grounded outlet. 3. Insert the included batteries into the remote control and flush the toilet.
Thank You Technical Support/Customer Service 7900 S Route 31 Crystal Lake, IL 60014 T: 847.458.2334 U.S. TOLL FREE: 877.339.5214 www.toiletseats.com support@biobidet.com www.biobidet.
