Handheld Bidet Sprayer S-100
Features Sprayer Page 7 Page 7 Page 7 Page 8 Page 9
Product Information FEATURES High quality ceramic valve Dual Sprayer 6’’Comfortable handle body Easy D.I.Y installation Ambient temperature bidet wash Adjustable water pressure 58’’ Metal spiral hose No electricity or batteries required One year warranty ATTENTION The Pearl S100 is equipped with a dual water pressure system. To ensure the safety of your home, and best performance of your new product, please turn off the water at the T-valve after each use.
Handheld Bidet Spray Holster T-Valve Shutoff (Be sure Flat Washer is inside end of T-Valve) Stainless Steel Supply Hose X2 Expanding nut (use to fix the spray holster on wall) Screw (use to fix the spray holster on wall)
CAUTION :Do not over tighten any connections.Over tightening connections can cause damage to the parts and cause ceaking. Notice:Observe all local plumbing,electrical and building codes PEARL When installing this unit,be sure that the water supply valve is fully turned off.Failure to do so can result in flooding and water damage. 1.Shut off water supply to toilet. Flush toilet to drain all water inside the tank.
PEARL 2.Disconnect the supply line from the toilet fill valve.Attach 7/8” T-Valve Shutoff to the threaded fill valve on your toilet. Be sure the 7/8” Flat Washer is in the T-Valve before installing.Position the T-Valve so that the shutoff handle is facing the front of the toilet. step 2 3.Reattach your existing toilet supply line to the bottom of the T-Valve. Be sure all connections are secure, and no leaking or water is present. step 3 4.
PEARL(cont) 5.Attach the Handheld Bidet to the other end of the supply hose. As a precaution, slide the level on the handheld bidet sprayer to “off”,which is away from the sprayer head. step 5 6.Mounting Spray Holster: Option1 : Toilet Mount: Carefully remove toilet lid and place holder in desired location. Option2: Wall Mount: Using a Phillips screwdriver, remove the plastic toilet clip. Find desired location on wall near toilet and use screw (included) to attach the Holster to wall.
PRODUCT OPERATION HOW TO USE THE PEARL 1. Open the T-Valve to allow water to flow to the Handheld Bidet sprayer. 2. Direct the Handheld Bidet to the appropriate area and slide the lever to the “on” position. 3. When finished, slide the lever to the “off” position and close the T-Valve. NOTE: THE T-VALVE MUST BE SHUT OFF AFTER EACH USE. Failure to turn off after each use may cause flooding and water damage. BBC Innovation is not responsible for damage that is caused by failure to follow this instruction.
Warranty Your Bio Bidet is warranted against defects in materials or workmanship for one (1) year from the date of original purchase. Defective parts or a defective product retuned to Bio bidet will be repaired with new or comparable rebuilt parts, or exchanged for a refurbished Bio Bidet product as determined by Bio Bidet in their sole discretion. This limited warranty given by Bio Bidet covers all defects encountered in normal use of this Bio Bidet product, and does not apply in the following cases: 1.
Technical Support/Customer Service Bio Bidet 7900 S IL Route 31 Crystal Lake IL 60014 T: 847-458-2334 Toll Free: 877-339-5214 support@biobidet.com www.biobidet.
