Owner Manual

24 25
OPERATION (CONT.) INSTALLATION
19. Nozzle Cleaning (Automatic & Manual)
Automatic
• This product has an automatic
nozzle self-cleaning function
that cleans the nozzle before
and after each use.
Manual
• Press the “Posterior”
button on the Auxiliary
Control panel on the
side of the seat without
occupying seat. The
nozzle will fully extend.
Gently clean the nozzle
with a soft cloth or
toothbrush.
• Press “Stop” button to
retract nozzle to stand
by mode.
• Shut off the water
supply shut off valve.
• Drain the toilet
tank completely.
• Then remove the
existing fill valve
water supply hose.
• Remove mounting bolts to
release existing toilet seat
from toilet.
• Remove existing supply
hose connected to the
toilet tank. Make sure
not to damage the water
supply hose.
• Install T-Valve at the
thread from tank.
• Beeping mode can be
enabled or disabled.
• To select or cancel silent mode,
press and hold down the “Stop”
and “Massage” remote buttons
simultaneously for approximately
3 seconds or until short beeps
• Single short beep - Silent mode
has been canceled
• Double short beeps - Silent mode
has been set
• The new setting will automatically
be saved if no other buttons
are pressed.
20. Selecting/Canceling Silent Mode
• Do not plug in before
installation.
• If you need an electric power
system or extension, please
consult a qualified electrician.
• Please contact our service
center (847-458-2334) when
you want to reinstall the
bidet product (move
or replacement).
1. Turn Off Water
2. Remove Existing
Seat & Lid
3. Connect T-Valve