BB1700 OWNER’S MANUAL
TABLE OF CONTENTS PRODUCT INFORMATION Important Safeguards.............................................4 Main Unit & Parts......................................................10 Dimensions....................................................................11 Remote Control.........................................................12 Operation......................................................................14 PRODUCT INSTALLATION Installation.............................................................
IMPORTANT SAFEGUARDS DANGER - To reduce the risk of electrocution WARNING - To reduce the risk of burns, electrocution, fire, or injury to the persons PLEASE OBSERVE THE FOLLOWING PRECAUTIONS BEFORE USING THIS PRODUCT READ ALL INSTRUCTIONS BEFORE INSTALLATION AND USE 1. Do not open the product to repair or remodel. Only qualified service personnel should service this product. Do not use attachments not recommended by the manufacturer. 2.
IMPORTANT SAFEGUARDS (CONT.) CAUTIONS BEFORE INSTALLATION: WIRING REQUIREMENT • THIS PRODUCT MUST BE PLUGGED into a regular voltage grounded GFCI outlet (North America 120V ac). The rated power consumption is 1400W. In locations where only a standard two-prong outlet is available, it is the responsibility of the user to install a grounded three-prong outlet. Using a higher voltage is dangerous and may result in a fire or other accident.
IMPORTANT SAFEGUARDS (CONT.) DANGER 8 • IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. Electric wiring has to be done in accordance with all local codes, or in the absence of local codes, with the National Electrical Codes. • The use of an extension cord is not recommended or advised. If it is necessary to use an extension cord, use only a three-prong extension cord (one to one), and a three slot built-in GFCI receptacle that will accept the plug on this product.
MAIN UNIT & PARTS DIMENSIONS Turbo Wash Nozzle PosteriorWash Nozzle Caution Label Lid Feminine Wash Nozzle Operation LEDWindow Deodorizer Control Panel for BB-170 0 Dryer Vent Drain / Quick Release Drain button Digital Occupied Sensor Heated Seat Nuts T-Valve L-Valve (2 pcs) Cone packing (2 pcs) Bolt Case (2 pcs) Water supply hose (for electronic bidet ) 1/2" O.D.
REMOTE CONTROL Stop all operation. Posterior wash. Feminine wash. Turbo Wash Dry washed area. Adjust the water pressure and warm air dryer temperature. Adjust the oscillation function and nozzle position (5 levels). Adjust the water temperature (4 levels). Adjust the seat temperature (4 Levels). When selected during the wash function, the nozzle oscillates automatically for a wider wash. When selected during the wash function,it starts the massage wash.
OPERATION Please press the “off” or “low”button to reduce the seat temperature after using. Special precautions should be taken for children, those who cannot adjust the temperature, and those who have sensitive skin. 2. DO NOT ALLOW CHILDREN TO USE THE TURBO WASH or VORTEX WASH FUNCTION! SUPERVISION IS STRONGLY RECOMMENDED FOR THE ELDERLY OR OTHER PERSONS THAT MAY HAVE LIMITATIONS IN BODY MOVEMENT, ILLNESS OR DISABILITIES. 1.
OPERATION (CONT.) 5. Posterior Wash 6. Feminine Wash 6. Press the “STOP” button when you feel your abdomen is full or wait until the “Turbo Wash”or “Vortex Wash”function stops, approximately 1 minute. 7. You will shortly feel the urge to push the water out of your colon, push the water and feces out as thoroughly as you can. 1. Press “Posterior Wash”. Automatically, the nozzle comes out and sprays warm water to posterior. 2. Additional functions during your Posterior Wash experience are available.
OPERATION (CONT.) 10. Warm Water/Seat Temperature Adjustment • 18 The temperature of water and seat are adjustable to the desired level by pressing the “WATER” and “SEAT” button. 11. Deodorizer • Deodorizer ON/Off (initial setting is Off) • Press button for 3 seconds (press the button again for 3 seconds, the function is canceled.) • After setting Deodorizer function, it is automatically activated when sensing the human body.
OPERATION (CONT.) 12. Oscillation (Nozzle Movement Function) 13. Nozzle Position Adjustment • • When using Posterior or Feminine Washing functions, pressing the “MOVE” button will provide a short-motion, front to back oscillating sprayfor a much wider cleansing experience. • You may change the position of the Oscillating spray by pressing the “MOVE” button again and “Front” or “Rear” buttons simultaneously. • Push the “MOVE” button again and the oscillation motion will stop automatically.
OPERATION (CONT.) 15. Auto Wash • • 16. Nozzle Shower If the “MASSAGE” function selected when user is not using wash functions, it automatically operates wash and dry function sequentially. Wash (30 Seconds) + Dryer (1 minute) then automatically stops. 17. DEODORANT ENERGY SAVER POWER BB-1700 • Press “Move” button while seat is not occupied. • Nozzle shower will initiate to clean nozzle and tip for about 20 seconds. • Nozzle will automatically retract once finished.
OPERATION (CONT.) INSTALLATION 18. Nozzle Cleaning (Automatic & Manual) Automatic • This product has an automatic nozzle self-cleaning function that cleans the nozzle before and after each use. • Beeping mode can be enabled or disabled.
INSTALLATION (CONT.) 4. Water Supply Hose 5. Installation Catch Plate 7. Assembly 1. Slide this product onto the catch plate centering the unit with the guide arrows on the base. 2. You will hear a click once this product is securely mounted to the catch plate. • Remove existing supply tube from fresh tank • If your shut off valve is 1/2” O.D compression size, use supplied 1/2” conversion nut as shown above. • 3. This product will feel a little loose on the toilet bowl.
INSTALLATION (CONT.) UNIT SEPARATION 9. Separation of Unit From Toilet Bowl Nozzle Change Nozzle Separation Nozzle Combination DO NOT TURN UNIT UPSIDE DOWN 1. Disconnect the power plug. 2. Close water supply shut-off valve. 3. Drain water from bidet seat using drainage as illustrated. 4. Remove bidet seat from toilet as illustrated.
MAINTENANCE Cleaning The Nozzle • • When the “Posterior Wash” button is pressed for 3 seconds without occupying the seat, the nozzle can be cleaned with a soft toothbrush. After cleaning the nozzle, push the “Stop” button once again, and the nozzle retracts itself. Cleaning The Body Of Unit • When you clean this product, do not use thinner, benzene or toilet bowl cleaner. It may cause damage to the surface of unit. • Use a wet cloth when you clean this product.
WATER DRAINING Draining the Warm Water Tank in the Unit Do not drink the drained water. Do not insert finger into the drain hole. Before draining, unplug the power cord and wait 30 minutes until the unit has cooled down. If you do not intend to use this product for 14 days or longer, TROUBLESHOOTING Trouble The washing water does not spray Cause 1. The water tank is not filled. 2. The shut off valve is closed. 3. Freezing inside the main unit or the water supply pipe. 1. Wait about one minute. 2.
SPECIFICATIONS Water Inlet Type Specifications BB-1700 Power Rating America or Canada: 120Vac, 60Hz, 1400W Type Direct Inlet flow type Water inlet pressure 0.04 ~ 0.74MPa(0.4 ~ 7.5 kgf/cm) Power Cord Wash Device Heated Seat Warm Air Dryer Device WARRANTY 1.2m (4 feet): AMERICA BBC Innovation LLC warranty its product to be free from manufacturing defects under normal use and service for a period of three (3) years from original date of purchase.
WARRANTY (CONT.) contractor, or write directly to BBC Innovation LLC, 7900 Illinois Rte 31, Crystal Lake, IL 60014. This written warranty is the only warranty made by BBC Innovation LLC. Repair or replacement as provided under this warranty shall be the exclusive remedy available to the purchaser.
INFORMATION TO THE USER WARNING - Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. Note: The manufacturer is not responsible for any Radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Thank You Technical Support/Customer Service 7900 S Route 31 Crystal Lake, IL 60014 T: 847.458.2334 U.S. TOLL FREE: 877.339.5214 support@biobidet.com www.biobidet.
