Owner Manual A7

14 15
INSTALLATION
If electric work is needed, please contact a qualified
electrician or service man only.
Remove the Existing Toilet Lid and Seat
1. Remove the nuts, washers, and cone packings from the
toilet seat and mounting bolts in the back of the toilet.
2. Remove the toilet seat, lid, and mounting bolts.
3. Keep them in case you need them.
Mounting the Plate
Place the mounting plate over each
mounting hole. Insert the mounting
bolts through the plate and mounting
holes. Slide cone packings and washers
onto the bolts and fasten tightly
with nuts.
Toilet Size (Elongated)
The toilet dimensions must be within
those shown on the right. Do not install
this appliance on a toilet that does not
meet these dimensional requirements.
Occupied Sensor
1. This appliance is equipped with
an occupied sensor.
2. The unit will not work unless
the seat is occupied.
Connecting the Water Hose
Connect the other end of the flexible hose from the
T-valve to the main appliance.
Using Inline Carbon Filter - The use of an external inline carbon water filter
is not required unless the unit is used in an area with extreme hardwater. If a
carbon filter is used, the filter must be replaced every 6 months. Inline carbon
filters can be purchased from any authorized Bio Bidet reseller.
Optional 1/2” Spare Nut
(Available by request)
*Shuto valve sizes may vary. If supplied parts do not fit, please call 877-339-5214