Owner Manual A7

26 27
SPECIFICATIONS
ITEM A7 SPECIAL EDITION
Standard power supply AC 120V 60Hz 1248W
Water
Supply
Way of connection Direct connection to tap water
Water pressure 0.07 MPa ~ 0.74 MPa
Cleansing
Spray for cleansing 700 (±150) ml/min
Spray for bidet 700 (±150) ml/min
Water capacity 740 ml
Spray temperature Room temp ~ 39°C (102.2°F)
Heater capacity 1200W
Safety feature
Thermal switch, temperature fuse,
floating switch
Dry
Air temperature Room temp ~ 60°C (140°F)
Heater capacity 280W
Safety feature Temperature fuse, Bimetal
Heated
Seat
Seat temperature Room temp ~ 39°C (102.2°F)
Heater capacity 48W
Safety feature Temperature fuse
Deodorization method -
Circuit breaker Within 15mA 0.03 second
Length of power cord 1.2m
Dimensions
(W) 481 mm (18.94 inches) x (L) 528mm
(20.79 inches) x (H) 160mm (6.30 inches)
Weight 4.6 Kg (10.14 lbs)
• Recommended water supply pressure are 0.1 ~ 0.69 MPa.
• The minimum available water supply pressure is 0.07 MPa,
however 0.1 MPa pressure, water spray pressure might not be adequate.
PROBLEM POSSIBLE CAUSE SOLUTION
Completely
fails to work
• Is there a power
cord outage?
• Is the power
cord unplugged?
• Are you sitting on
the seat correctly?
• Check for power cord
failure or a tripped
breaker.
• Plus the power
cord in properly.
• Sit on the
seat completely.
Water does
not spray
• Is the water shuto
valve closed?
• Is the strainer clogged?
• Are the nozzles clogged?
• Is the water purifying
filter clogged?
• Check for any water
leaking or dripping
• Clean the strainer
• Clean the nozzles
• Change the water
purifying filter
Water is
leaking or
dripping
• Are all the hoses
tightened up properly?
• If the water is still
leaking or dripping,
contact your dealer
Seat or
water is
not warm
enough
• Is the temperature
set to OFF?
• Is the appliance used in Eco
mode during cold weather?
• Reset the temperature.
• Press “Eco” again to
release the function.
BEFORE CALLING FOR SERVICE